RAWshop - Ross’ Alliteration Workshop

[rosco]

I did a full overall, but apparently it was too thin and not able to effectively stop Cf dust and splinters. Need to look for some better gear.

Have a mate with a water jet tho, probably easiest to get him to cut out for me if i make any more.
Accurate, fast and most importantly not itchy.

[glyphiks]

@Cfelzien

cover yourself with vaseline

@BillGordon get in here and show them how it’s done

[Cfelzien]

@rosco

a mate with a water jet tho,

I need better friends.

[glyphiks]

@Cfelzien

I need friends

FTFY

[moon]

[rosco]

[rosco]

Enclosure prep begins
Going large

[rosco]

Not sure if this will hold the camber shape, will see.

[Cfelzien]

I always have to put something down the sides to hold the curves.

[PedroMcJimenez]

Damnit @rosco that turned out gorgeous
Nice work! I dig the textured look of the rails

[rosco]

Cheers, good advice.

Unclamped and the base layer wasn’t ready enough to hold the shape well.

Gluing a layer to sides and will see where that ends up.

[glyphiks]

Damn thats a sweet clamp up shot. I like to use a foaming polyurethane glue for those types of glue ups. The glue foams into the relief cuts and tends to hold it’s shape nicely, especially if you have a top and bottom layer as well

[rosco]

Ooh name / link?

[glyphiks]

I get it from bunnings

[BillGordon]

Glorious. Serious BOTY potential here.

[rosco]

Hmm… no dice here.
More research needed.

[PedroMcJimenez]

@glyphiks

foaming polyurethane glu

@rosco

no dice here

This should be similar I believe. Not sure if the water activated aspect works this process though.

[Cfelzien]

Foam glue I’ve used this kind twice with ok results.

[glyphiks]

Meh, i’m never gonna give up my foaming glue. Shit is wild.

[rosco]

sounds good, can’t seem to get it here (web search)

Improvising