No, not yet. Still need to get motors and battery for it.
Turns out I know of some pretty good battery builders 
Y’all should just publicly shame me until I get some quality threads on here 
She has a 1:4 Kaly helical GD… so stealthy, all I hear is the motors singing and the wind blowing.
1 Like
6 Likes
One of my motors makes a pretty weird noise. It’s super loud and it’s only around a certain speed so it’s probably some sort of vibration noise but I have grown a bit fond of it.
1 Like
That worked out way better than I thought. Noice!
4 Likes
When they say Al runs 10s, you know what is meant
4 Likes
The beer to work ratio seems about right.
7 Likes
Lol. Many people have assured me that prints are fine as risers… mybe i should make a mold and pour from urethane 
Some have standards…
just don’t use it on top of the deck please, even if it would look nice
2 Likes
@ducktaperules this is genius, I have a future design I want to do similar to this but each esc would go on the side and BMS and rest of the electronics on the rear or front of the pack, this is way better and easier to wire, but does make the pack taller
Do you plan to raise the base so the deck can flex freely?
No, quite the opposite. I hope to bolt this down as solid as possible to strengthen the deck and remove as much flex from the center as possible. Hopefully this will also allow me to narrow the center of the deck and make the shape a little more interesting whilst reducing the weight.
1 Like
Looking for that test, this also make the enclosure slim since there is no gap
How’d you manage that?
I went to bed and woke up to this 
i imagine that part of the print lifted
1 Like
I found out recently I was putting way too much glue. Would apply Elmer’s spray adhesive before every print…fucking needed a shovel to take the prints off the bed.
What are you using to stick prints?
PS: was really using a floor scraper to remove prints 
1 Like
Spray adhesive on kapton tape. I’m gonna abandon the abs idea and print 2 part negative molds for these out of petg and pour them out of urethane. That should keep @Andy87 happy 
2 Likes
Is there a reason for using spray + kapton?
1 Like