Reply to "🖼️ All the Pictures and Nothing of the Else"

The Watercooler
419

This is true :v:

3 Likes
420

Mint as fuck @Linny! Holy shit that’s clean.

7 Likes
421

Thanks Andrew! I think this is my magnum opus.

6 Likes
422

Depends there’s 2 different types of faille bending and snapping

ABS PETG are both good at avoiding snapping because thay bend and disform. At work a Aluminum scaffold bar has a higher working limit than a steel one because a steel one shatteres when it fails we’re a Aluminum one will bend.

For a riser you want solid not deforming it look at cheaper pla+ over abs or a carbon fiber reinforced filiment even better

1 Like
423

I’ve ordered 60D urethane. Gonna use the prints to make molds with liquid silicone, then pour the risers with the 60D urethane.

Printing risers now in PETG with 2mm walls and 50% infill, will ride with these until I have made the urethane ones.

1 Like
424

My love for this is palpable. :sweat_drops:

1 Like
425

I’ll put the design on thingiverse tomorrow :+1:

1 Like
426

And the verdict compared to channel trucks is?

5 Likes
427

The future is here :drooling_face:

1 Like
428

I just had MBS Matrix 2s on this board and these dive into corners really well at low speeds, effortlessly. I like how wide the hangers are - 354mm track width with MBS matrix 2s. Im not a speed demon so I’ll wait for other feedback for that. Ill put the rear truck on tomorrow. You do need to mount the trucks in outer positions because of hanger offset.

2 Likes
429

@glyphiks meet up with @BillGordon ?

8 Likes
430

Lol, that’s my 7yr old daughter’s board :rofl:

7 Likes
431

Being esk8 twins with Al’s rad little daughter is a compliment. Thanks.

5 Likes
432

Baahahahahahahahahah! Best part of the video for sure

1 Like
433

And they have the old ones in 200kV now also in stock :see_no_evil::see_no_evil::see_no_evil:
I don’t need those motors!!! I DON‘T :point_up::point_up::point_up::see_no_evil:

3 Likes
434

literally, 1 week after i purchase the 63100… I’m raging rn

3 Likes
435

But yours are sealed from the back, no?
Probably more important then those 5mm extra :sweat_smile:

2 Likes
436

300W + extra 2s rating + 5mm (ladies)

4 Likes
437

1s extra :stuck_out_tongue_winking_eye::joy:

I would give too much on the listet ratings anyway. A 140kV motor should have different ratings as a 200kV motor but the specs are always the same on their side.

Hope somebody buys one of the V2s and measure the actual stator size too :pray:
Always good to see what’s inside.

2 Likes
438

Nope not sealed either.