Reply to "🖼️ All the Pictures and Nothing of the Else"

The Watercooler
424

My love for this is palpable. :sweat_drops:

1 Like
425

I’ll put the design on thingiverse tomorrow :+1:

1 Like
426

And the verdict compared to channel trucks is?

5 Likes
427

The future is here :drooling_face:

1 Like
428

I just had MBS Matrix 2s on this board and these dive into corners really well at low speeds, effortlessly. I like how wide the hangers are - 354mm track width with MBS matrix 2s. Im not a speed demon so I’ll wait for other feedback for that. Ill put the rear truck on tomorrow. You do need to mount the trucks in outer positions because of hanger offset.

2 Likes
429

@glyphiks meet up with @BillGordon ?

8 Likes
430

Lol, that’s my 7yr old daughter’s board :rofl:

7 Likes
431

Being esk8 twins with Al’s rad little daughter is a compliment. Thanks.

5 Likes
432

Baahahahahahahahahah! Best part of the video for sure

1 Like
433

And they have the old ones in 200kV now also in stock :see_no_evil::see_no_evil::see_no_evil:
I don’t need those motors!!! I DON‘T :point_up::point_up::point_up::see_no_evil:

3 Likes
434

literally, 1 week after i purchase the 63100… I’m raging rn

3 Likes
435

But yours are sealed from the back, no?
Probably more important then those 5mm extra :sweat_smile:

2 Likes
436

300W + extra 2s rating + 5mm (ladies)

4 Likes
437

1s extra :stuck_out_tongue_winking_eye::joy:

I would give too much on the listet ratings anyway. A 140kV motor should have different ratings as a 200kV motor but the specs are always the same on their side.

Hope somebody buys one of the V2s and measure the actual stator size too :pray:
Always good to see what’s inside.

2 Likes
438

Nope not sealed either.

439

Oh ok. According to the picture they should look like this

image
image1125×1195 381 KB

Maybe they changed pictures. Don’t remember the old ones.

1 Like
440

Mesh screening, battle hardening and pot the sensor pcb

Hoping the low kv makes them a little conservative on the series rating.

I plan to pump max 60A into each motor given 7p of 30Q, iirc 30Q can do a burst of 20A but 15A continuous

1 Like
441

done bro, but still, for the same price i could have gotten 600W more of unusable power, 5mm longer

and more boasting specs

1 Like
442

I bet the stator is the same, the 63100 did not have room for a hall sensor pcb according to Bruno. You can add encoders instead?

Not sure how HFI is for ATB? I’ve tried it only on thane and I still get more stuffer than Spider

2 Likes
443

I run HFI on the 63100 and it works perfectly!

2 Likes