I just had MBS Matrix 2s on this board and these dive into corners really well at low speeds, effortlessly. I like how wide the hangers are - 354mm track width with MBS matrix 2s. Im not a speed demon so I’ll wait for other feedback for that. Ill put the rear truck on tomorrow. You do need to mount the trucks in outer positions because of hanger offset.
2 Likes
Lol, that’s my 7yr old daughter’s board 
7 Likes
Being esk8 twins with Al’s rad little daughter is a compliment. Thanks.
5 Likes
Baahahahahahahahahah! Best part of the video for sure
1 Like
And they have the old ones in 200kV now also in stock 
I don’t need those motors!!! I DON‘T 
3 Likes
literally, 1 week after i purchase the 63100… I’m raging rn
3 Likes
But yours are sealed from the back, no?
Probably more important then those 5mm extra 
2 Likes
300W + extra 2s rating + 5mm (ladies)
4 Likes
1s extra 
I would give too much on the listet ratings anyway. A 140kV motor should have different ratings as a 200kV motor but the specs are always the same on their side.
Hope somebody buys one of the V2s and measure the actual stator size too 
Always good to see what’s inside.
2 Likes
Nope not sealed either.
Oh ok. According to the picture they should look like this
Maybe they changed pictures. Don’t remember the old ones.
1 Like
Mesh screening, battle hardening and pot the sensor pcb
Hoping the low kv makes them a little conservative on the series rating.
I plan to pump max 60A into each motor given 7p of 30Q, iirc 30Q can do a burst of 20A but 15A continuous
1 Like
done bro, but still, for the same price i could have gotten 600W more of unusable power, 5mm longer
and more boasting specs
1 Like
I bet the stator is the same, the 63100 did not have room for a hall sensor pcb according to Bruno. You can add encoders instead?
Not sure how HFI is for ATB? I’ve tried it only on thane and I still get more stuffer than Spider
2 Likes
I run HFI on the 63100 and it works perfectly!
2 Likes
Still think if you extend the axle an make a custom motor mount with bearing on the can side to make dule drive singe VESC it would then be a viable single drive board
2 Likes
Don’t you see @Lee_Wright thirsty eyes looking at your pictures??? That’s all just love Andrew.
6 Likes
