@glyphiks that was a quick delivery 
2 Likes
Yeah bro, they did gooood
3 Likes
So fast it’s almost like they shipped from a factory in china.
Shipping label is from US 
3 Likes
thank you! yes I have to admit i may have completely forgotten about fish paper under the balance wires I will go ahead and add it now thanks!
3 Likes
Woooaaaahhh that’s a serious setup! Would love to see a video tour explaining all the bits and bobs! Could be an epic start to your workshop thread 
12 Likes
Dare you to send it!
5 Likes
Seriously!
@Battery_Mooch if you’re ever looking to adopt a very large manchild, my father is dead to me and I love playing with 'scopes & various meters.
Just sayin’
9 Likes
I’m gonna be very sad if she didn’t cross that on that board. Don’t break my heart… Plz
6 Likes
Careful. Andrew is “handsy.”
7 Likes
I’ll start the paperwork.
I have a LeCroy 9410 you can play with. 
9 Likes
Welp… I never thought I’d have to say this to ya Mooch. But back off dude… 
Stop it Andrew. We’ve talked about this.
9 Likes
those gear drives… like 'em or love 'em?
4 Likes
Love them so unbelievably much. They are so quiet. Herringbones are my shit! I want all gear drives to be herringbone. Too bad it’s so expensive to machine.
4 Likes
Trampa Holypro 35 with e-toxx flaps
3 Likes
Skip the salon one day a week. 
4 Likes
Is there any way to support the centre?
Is there a need to?
Seems like an awful lot of leverage on the mounts
4 Likes
There are two ways to do so.
You can place the mounts so close that the motors touch each other and support them,
Or you can install some kind of support like the etoxx matrix2 motor protection. Just that you make the hole just as big as the motor bell.
In the picture it is just a mock up with plastic adapter. I think it should be fine with alu adapter in future.
We will see. All that is just for science anyway.
4 Likes