Seriously!
@Battery_Mooch if you’re ever looking to adopt a very large manchild, my father is dead to me and I love playing with 'scopes & various meters.
Just sayin’
9 Likes
I’m gonna be very sad if she didn’t cross that on that board. Don’t break my heart… Plz
6 Likes
Careful. Andrew is “handsy.”
7 Likes
I’ll start the paperwork.
I have a LeCroy 9410 you can play with. 
9 Likes
Welp… I never thought I’d have to say this to ya Mooch. But back off dude… 
Stop it Andrew. We’ve talked about this.
9 Likes
those gear drives… like 'em or love 'em?
4 Likes
Love them so unbelievably much. They are so quiet. Herringbones are my shit! I want all gear drives to be herringbone. Too bad it’s so expensive to machine.
4 Likes
Trampa Holypro 35 with e-toxx flaps
3 Likes
Skip the salon one day a week. 
4 Likes
Is there any way to support the centre?
Is there a need to?
Seems like an awful lot of leverage on the mounts
4 Likes
There are two ways to do so.
You can place the mounts so close that the motors touch each other and support them,
Or you can install some kind of support like the etoxx matrix2 motor protection. Just that you make the hole just as big as the motor bell.
In the picture it is just a mock up with plastic adapter. I think it should be fine with alu adapter in future.
We will see. All that is just for science anyway.
4 Likes
Ahh yes. If i was doing them i would definitely want them secured together in the middle. Not just resting, but actually properly bolted together. Keen to see your progress!
3 Likes
I was just going to ask if you could bolt them together. Is that a thing?
2 Likes
I don’t see why not 
3 Likes
There are 3x M3 holes in the back of the motor.
I need to align them, but after that it should be possible to fix the motors together with some metal parts.
10 Likes
@glyphiks
🖼️ All the Pictures and Nothing of the Else - #450 by glyphiks
Something is off there.
How can your duty cycle be as high as 120%?
6 Likes
GOAT gives you a 25%+ boost!
5 Likes
There’s a duty scaling bug we’re tracking down, but your consumption would be because you’re only logging a single ESC. Check your Robogotchi configuration.
If you could export that log and send it to me on Telegram I’ll add it to the pile.
3 Likes