There are two ways to do so.
You can place the mounts so close that the motors touch each other and support them,
Or you can install some kind of support like the etoxx matrix2 motor protection. Just that you make the hole just as big as the motor bell.
In the picture it is just a mock up with plastic adapter. I think it should be fine with alu adapter in future.
We will see. All that is just for science anyway.
Ahh yes. If i was doing them i would definitely want them secured together in the middle. Not just resting, but actually properly bolted together. Keen to see your progress!
There are 3x M3 holes in the back of the motor.
I need to align them, but after that it should be possible to fix the motors together with some metal parts.
There’s a duty scaling bug we’re tracking down, but your consumption would be because you’re only logging a single ESC. Check your Robogotchi configuration.
If you could export that log and send it to me on Telegram I’ll add it to the pile.