which version of the freesk8 app are you running? i would have expected logs from your neck of the woods look like this
9 Likes
i flip the screenshots for the greater good
7 Likes
Tell me about this
3 Likes
also interested, is that an extruder and hotend all in one?
3 Likes
That is sexy as hell dude. But that BMS 
You should look into getting some teflon wire dude, to help keep the pack height down a few mm…
14awg silicone on the left, 12awg teflon on the right. The brand I use is called Raychem
8 Likes
The dots over solder points super clean 
3 Likes
Gotta use them dots Ross, i hate seeing them go to waste
4 Likes
i reckon the highest i have ever been was doin dots with Maoris
5 Likes
Don’t waste the dots, they waste you 
Me as well 
3 Likes
Nah he’s got a little pancake stepper on there, just haven’t seen this version of the bmg extruder
2 Likes
Haven’t used it yet…
2 Likes
It’s brand spanking new I pre ordered it lgx ff
4 Likes
Looks fancy. Ill check it out
2 Likes
Thanks for the tip bro! Will look into it for sure
2 Likes
The 18s bms is freaking huuuuuge, bestech, has a smaller one but no BT
2 Likes
Aren’t they the same thing?
3 Likes
I knew it was a bad idea to print all of these at once 
one went down and took the rest with it. Birds nest city. No photos cos i was so angry i ripped them all off and smashed them into tiny pieces.
@DougM your walls are too thin where the curvature meets the flat face.
3 Likes
I didn’t have any problems printing his remotei just wish it had a lanyard hole…