Looks fancy. Ill check it out
2 Likes
Thanks for the tip bro! Will look into it for sure
2 Likes
The 18s bms is freaking huuuuuge, bestech, has a smaller one but no BT
2 Likes
Aren’t they the same thing?
3 Likes
I knew it was a bad idea to print all of these at once 
one went down and took the rest with it. Birds nest city. No photos cos i was so angry i ripped them all off and smashed them into tiny pieces.
@DougM your walls are too thin where the curvature meets the flat face.
3 Likes
I didn’t have any problems printing his remotei just wish it had a lanyard hole…
Try squeezing it
@glyphiks, It’s 070 walls and pretty tight tolerance to the PCB so requires a pretty good printer. The inner cage requires a really good printer. I couldn’t do it on my Prusa, had to use a printer at work.
Also, I printed it the other way around with supports. If you’ve got water soluble supports it would be a lot better on account of the tolerances.
I’ll take a look at beefing up that area.
@TheRef Yes, I forgot about lanyard holes, and I would probably add a 5th screw to the heel area as well. If I can make some time I might release a 1.1
3 Likes
it’s his pic. These stickers are still on their way to me.Circut weeding tool 
3 Likes
I couldn’t get my case on even though I thought it printed well.
3 Likes
good god! 40mph? that’s crazy. which setup is this, because your wh/km is super low!
2 Likes
oh no, IB. Who dares go there!
2 Likes
This is my space invader. The consumption is halved because of some issue with robogotchi and 5.1 FW. Need to go to 5.2 I suppose.
2 Likes
Love the recessed power button
3 Likes
Why the hell do I have that ugly mug on my ride log!?
8 Likes
To remind you not to drink and drive 
5 Likes
Fair enough, but seriously, is this a subtle way of telling me I need to update my fw or sw or something?
3 Likes