Did you mean middle or pointer finger hole? If so, yes, at least this mock up was to make an easy flat print surface.
3 Likes
Yes! This is perfect!
3 Likes
Sorry- yeah I meant ‘fingerhole’ not thumb.
My only thought on that is you might use a deep filet on either side of it, or even angle it a bit away from perpendicular. I found the hole on the HMP needed some adjustment like that.
4 Likes
adventuring.
definitely can see the value in an SLA print. my battle with supports not going too good.
still excited though. 
3 Likes
Oof. What are you using for a slicer?
I’ve found that simplify3D still cannot be beat in its support generation.
3 Likes
prusaslicer
I’ve mostly avoided supports so don’t have a lot of experience messing with them.
2 Likes
If you’re on a Prusa, I can throw my gcode up with simplify 3d supports. Mine turned out pretty decently.
(This is not with supports hah)
The bottom shell needs a bit of adjustment for some clearance issues with the battery cable, I’ll push updated files up shortly.
3 Likes
hmm. looks better than mine. 
looks like you printed the topcase outward side down. I so no supports above. I did the opposite. I should try that. how’d the inside of your bottom case come out?
2 Likes
Print orientation im using is shown here:
2 Likes
interesting, mine was 0.2
thanks… yeah I got too clever and went for the outershell being on top. so top case opposite of your orientation.
2 Likes
Added a cutout here for the battery power cable as it was cutting it a bit close. Bottom model has been updated:
Going to print up this new bottom shell and then roll the dice on a set from Shapeways.
9 Likes
I am an impatient manchild.
6 Likes
I was pretty close to jumping the gun on. you. but now you did it. I’ll see if I can make this ABS print work and try it before i do the upgrade to nylon sls.
4 Likes
If this one works out I’m trigger pulling a small batch asap.
This first set is coming via priority print service.
6 Likes
Yeah… so I think I figured out how to move the bolts to the bottom without changing the overall geometry, so I’m gonna take a crack at rev6. Why am I like this?
5 Likes
I’m wondering if you can load an updated .stp file… I wanna take a hack at a sliding door thingie like on the Bruce of Olde
You know… For science…
2 Likes
Sure thang babe. You want top & bottom shells or the base primitive model? Or all?
Too late, you get all 3:
Please note that the ‘100-primitive-rev5’ model is full original 100% scale, where the shelled/featured rev5 top/bottom files are at 91% scaling.
3 Likes
dude. you totally pucked up that bruce.
2 Likes