What are you for doing the epoxy? If you draft the front and back of that form a little, you could pop a cast directly off of it. Or even do a hard mold? What’s the plan mr. masochist?
4 Likes
Still gotta so some sanding/shaping, then i’m gonna cut the buck into it’s segments.
The buck is hollow, once i’ve cut it i’m gonna haveto fill in the ends.
I’m gonna go for a silicone mold again this time, just gonna use a lot less of the shit 
6 Likes
Lol. You’re just a glutton for punishment.
On a serious note. If you’re doing another brushup mold it’s fine. If you do a matrix watch out for your hollow core. Any gap and it will fill with rubber…
4 Likes
Just gonna pour it, but do a much thinner silicone jacket, and then try and vac a fibreglass jacket over that
5 Likes
You can break up the jacket if you need to as well.
3 Likes
makes me wanna have a bottom mounted pack for my haero too…
7 Likes
Looks great al. But I’m confused, I thought you said you were cutting it up. Change of plans?
2 Likes
The plan remains. I just wanted to get the shape right before I ruined it
I’m just glad that work pays for all the bog.
11 Likes
Lifesaving medical supplies. (Beer.)
8 Likes
Only just enough in there for an emergency ration
5 Likes
Thats the resin fridge
7 Likes
Ja ja… 
5 Likes
I like your painting risers. 
3 Likes
Essential tools of the trade.
6 Likes
Final primer coats going on. Dumping a whole can of aerosol primer onto them and then moving on to making a flange.
I always seem to forget how much work goes into this process 
11 Likes
Lol this enclosure is so thiccc. Its a little too thicc, so i’m making a flange to go round the buck and slightly reduce the total enclosure depth.
Shamelessly stole this idea from @rosco
This will also allow me to have the perfect flange shape already set in the part when I release it from the mold.
Chop strand fibreglass is shit.
13 Likes