Randomness begets Randomness The off-topic discussion thread

The Watercooler
275

20200928_144802
20200928_1448022268×4032 2.42 MB

20200928_144806
20200928_1448062268×4032 2.34 MB

Basically unobtainium at this point, Janux gear drives for TBcnc trucks. Got the last set he ever made before he left esk8 DIY world. I think TB6380 miiigt fit, but i don’t have any at the moment and Dex is out of stock. Also been wanting to see what all the battle hardened rage is all about with these flipskys. Going to run the 190kv at 14s on the new spintend dual 75v vesc

6 Likes
276

Super clean can’t wait to see the final build :call_me_hand:

3 Likes
277

Thanks Bro! I am exited too! will be my first build at a voltage higher then 12s

5 Likes
278

IMO, you’re better off going with the higher kv motors and gearing down. Unless you’re stuck with limited ranged gear-drives, I guess. GDs aren’t really conducive to running big power, imo, b/c of their ratio limitations (and the fact that most of them use plastic gears :scream:)

3 Likes
279

Where did he go?

2 Likes
280

This just reminded me. Does anyone here have the as150 switch print files? The ones from thee we do not name?

1 Like
281

New is relative :sweat_smile: I fucked the calibration couple months back wanting to level the bed. Just got enough spare time to fix it. But yes I’ll gladly print anything needed

3 Likes
282

My buddy’s printer failed at a Kweld case a month ago and the mess is still on the build plate I think lol

His printer is about as reliable as my builds.

2 Likes
283

I was getting to these points about quarterly, so I sold the piece of shit printer that was leaving me high and dry, and I bought a Prusa lol.

5 Likes
284

I’ve got a prusa clone. Does the job till I learn to use my fusion 360 properly. Then I’ll have a reason to upgrade

2 Likes
285

ahem derail

2 Likes
286

FUCK!!! THIS IS WHY I WENT DIRECTLY TO THE RANDOM THREAD…it’s all his fault🤣

3 Likes
287

Feel free to migrate post 48 and after. You know, if migrating is something yall do. I dont know the rules, i just work here man.

3 Likes
288

Nobody knows the rules :expressionless:

i blame @BillGordon

4 Likes
289

Then dooooo iiiitttttttt

3 Likes
290

this is something that we have agreed as staff should not be a common occurrence. Breaking the unwritten rules for you Benji

4 Likes
291

You two are cute… Sup… :kissing_heart:

6 Likes
292

I make good girls go bad :kissing_heart:

6 Likes
293

FASCISTS!! AHHHHHHH!

Poor @Flasher trying to play by the rules :joy:

4 Likes
294

I always wondered if you could quote a deletion

2 Likes