IMO, you’re better off going with the higher kv motors and gearing down. Unless you’re stuck with limited ranged gear-drives, I guess. GDs aren’t really conducive to running big power, imo, b/c of their ratio limitations (and the fact that most of them use plastic gears 
)
3 Likes
Where did he go?
2 Likes
This just reminded me. Does anyone here have the as150 switch print files? The ones from thee we do not name?
1 Like
New is relative 
I fucked the calibration couple months back wanting to level the bed. Just got enough spare time to fix it. But yes I’ll gladly print anything needed
3 Likes
My buddy’s printer failed at a Kweld case a month ago and the mess is still on the build plate I think lol
His printer is about as reliable as my builds.
2 Likes
I was getting to these points about quarterly, so I sold the piece of shit printer that was leaving me high and dry, and I bought a Prusa lol.
5 Likes
I’ve got a prusa clone. Does the job till I learn to use my fusion 360 properly. Then I’ll have a reason to upgrade
2 Likes
ahem derail
2 Likes
FUCK!!! THIS IS WHY I WENT DIRECTLY TO THE RANDOM THREAD…it’s all his fault🤣
3 Likes
Feel free to migrate post 48 and after. You know, if migrating is something yall do. I dont know the rules, i just work here man.
3 Likes
Then dooooo iiiitttttttt
3 Likes
this is something that we have agreed as staff should not be a common occurrence. Breaking the unwritten rules for you Benji
4 Likes
You two are cute… Sup… 
6 Likes
I make good girls go bad
6 Likes
I always wondered if you could quote a deletion
2 Likes
They are pretty easy to figure out… just have to set them up right from the factory… mine still gives me a little trouble every now and then… I used petg for the first time and that was a little different.
2 Likes
Breaking unwritten rules is a conundrum in itself.
2 Likes
They are also so cheap now it’s like why not get one.
2 Likes